Radiator Fan Motor Electrical Connector for Ford Taurus or Lincoln MKVIII vehicles.

This is a popular electric fan often used for retrofits and cooling system conversions due to its high power and cooling capacity.

Assemble your own connector instead of buying a pigtail to reduce splices and to ensure a clean and quality installation.

The pigtails in the aftermarket with brown/blue/black wires use lower grade GPT wire that doesn't have the temperature rating we suggest for engine compartment use. Instead, use your own cross linked polythene jacketed (XLPE/TXL/GXL) wire to build a high quality wiring harness. Alternatively if replacing a factory connector you can maintain the factory appearance without the need to splice this in.

We strongly recommend soldering the terminal to the wire once crimped unless you are confident you have the correct crimping tool for the job. Any high resistance at this crimp would cause the terminal to heat up so soldering is highly recommended to reduce this.

Suggested wire gauge is 10 awg for the high speed and ground wires, 12 awg for the low speed.

We also offer this connector as a pigtail using proper automotive grade wire with soldered connections - please see our other listings for this. We can supply this connector with any length of wire you specify, please contact us for this.

Kit contents:

1 x Black 3 pin connector housing

1 x Red terminal retainer clip

1 x Black rear wire seal retainer

1 x Blue silicone wire seal

3 x Tin plated crimp terminals (suggested to solder to the wire)